Waterproofing
-
Vulkem 350NF SL
$235.00 -
Kryton Krystol Plug
As part of the Krystol Leak Repair System, Krystol Plug is a rapid-setting hydraulic cement product that when mixed with water is used to stop flowing water and repair leaking cracks, holes and joints in concrete. Krystol Plug sets hard within 2 minutes and has high-compressive strength, which allows it to stop water even under high-hydrostatic pressure. Stopping water flow then allows permanent repair of the leak using Krystol technology.
-
Kryton Krystol Repair Grout
As part of the Krystol Leak Repair System, Krystol Repair Grout is a crystalline concrete waterproofing product that stops the flow of water to permanently repair leaking cracks, holes and joints in concrete, and can also be used to resurface and waterproof defective, damaged or deteriorating concrete. The grout employs advanced fiber technology and shrinkage controlling additives to prevent cracking.
-
Kryton Krystol T1
Krystol T1 is a surface applied crystalline slurry treatment that transforms new or existing concrete into a permanent waterproofing barrier.
Krystol T1 lowers the permeability of the concrete to protect against the ingress of water and waterborne chemicals. Since it becomes integral to the concrete, it can be applied to either the positive (wet) or negative (dry) side of the water pressure which allows reliable hydrostatic waterproofing protection and remediation for even the most difficult applications.
-
Euclid Diamond Clear Vox (5-Gal)
Diamond Clear VOX is a VOC compliant, water-based acrylic curing and sealing compound. This product provides a quality cure to freshly placed interior or exterior concrete while assuring total resistance to yellowing from ultraviolet exposure. Diamond Clear Vox promotes proper hydration of cement in new concrete by preventing rapid loss of moisture. Used as a sealer, Diamond Clear Vox helps concrete repel water and gives surfaces a semi-gloss appearance.
-
Vulkem 350 R
Vulkem 350 Base Coat is a single–component urethane membrane that bonds firmly to clean, dry concrete and metal. It retains its integrity even if substrate movement causes hair–line cracks of up to 1/16″ (1.5 mm). If cut or damaged, Vulkem 350 will prevent water migration between itself and the substrate. Vulkem 350 is available in roller (R) and in self–leveling (SL) grade for vertical and horizontal application.
-
Tremproof 250 GC SL
$252.00 -
Tremco Exoair 130 White
Tremco Exoair 130 White 18.9 L 5gal
-
Vulkem 350 SL
$235.00 -
Tremco Primer Epoxy Kit
Tremco® Epoxy Primer is a two-component (1:1) primer used as a compatible tie-in to create connectivity between TREMproof® below-grade waterproofing membranes, Vulkem® urethane coatings and ExoAir® air barrier membranes.
-
Vulkem 191 Primer (1-Gal)
Vulkem® Primer #191 is a quick drying, one-part, moisture-curing primer used as a urethane-to-urethane tie-in that prepares surfaces of cured Vulkem urethane sealants, coatings and membranes to be sealed with a fresh coat. – 3.8L – 1 Gal
-
Mesh Membrane Tietex 272 – 40″
T326 GRADE (2.75 OZ) Firm-Finish Stitch Bonded Polyester Roofing Reinforcement Fabric, for Waterproofing – 40″ X 324′ ROLL.