
- Description
Description
3M Firestrap 1.5″
Related Products
-
3M FireDam Spray 200
3M FireDam Spray 200 is a sprayable material that dries to form a tough, elastomeric coating. It will firestop building joints, curtain wall perimeter joints and through penetration seals to control the transmission of fire, heat, smoke and noxious gas. This water-based firestop sealer is applied with conventional airless sprayers, dries quickly and cleans up easily.
-
3M Restricting Collar 4 3/4″ x 25′
3M Restricting Collar 4 3/4″ x 25′
-
TREMstop Acrylic – Limestone
TREMstop® Acrylic is a gunnable acrylic latex sealant designed for use in firestop applications, including both joints and through-penetrations.
-
3M Fire Barrier CP 25WB+
3M™ Fire Barrier Sealant CP 25WB+ is a high-performance latex-based intumescent firestop sealant. When properly installed, this product provides up to four hours of fire protection in tested and listed systems.
-
3M Fire Barrier Moldable Putty Pads 7in x 7in
3M Fire Barrier Moldable Putty Pads MPP+ are a one-part firestop material used in various fire-rated assemblies, such as electrical box protection. Designed to prevent the spread of fire, smoke and noxious gasses, this intumescent material comes ready to use in convenient 1/10” (2.54 mm) thick pads that are conformable by hand with no mixing or tools. Pads are firestop tested up to four hours.
-
Nuco Self-Seal GG-200
Self-Seal® GG-200 is a single-component, low modulus, non-slumping silicone firestop sealant designed for horizontal and verticle applications. It forms a pressure tight seal resistant to water, smoke and toxic gases, see Self-Seal® UL and cUL firestop systems for W (Water tightness) and L (Air Leakage) Ratings. The sealant is also resistant to cracking, ultraviolet radiation and ozone.
-
Rockwool 930
$96.24 -
3M Firestrap 3″
3M Firestrap 3″
-
3M Fire Barrier Device 6″
3M Fire Barrier Device 6″
-
TREMstop MP 7.25″
TREMstop® MP is a moldable putty preshaped into three pad sizes to fit different electrical boxes. Release liners are on both sides of the pad and one must be removed for installation.